Autograph

Die Types: HA, Shear

• Sheared nameplates 

• Can emboss with Electronic Feed Shear (Cannot be larger than approx 5.50 x 4.00)

• Hand hole only 

• Electronic Shear: 

• Larger plates cannot exceed 8” row width  

• Smaller plates that are <0.5” on either the Height or Length become very challenging 

• If you have a plate that needs to be sheared that is < 0.5” please see manufacturing lead first to make sure this is something they can do 

• Maximum quantity of 5,000 

• Blanking Shear: 

• Holer only extends to 7.3” row width. Anything wider will need to be completed individually in hand ops.   

• Can go as small as .25 between cuts but this small size does present some challenges from manufacturing side.  It is possible but takes longer to produce handling small parts. 

• Check with TS if larger quantity 

• Autograph mainly used for Anodized Aluminum blank nameplates 

• Printed Autograph nameplates are screen-printed.  These have been switched over to our Signature line except for a few exceptions approved by Tech Spec. 

• Must be Autograph part if customer is engraving or etching on the tag 

• Individual tags 

• Tabbed dies available 

• Progressive dies available or optional holes available for mechanical fasteners 

• If progressive die marked ‘Removable Punch’ die can be used without holes.        

• Change all hole info in configurator to zero 
• Holes optional 
• Premask optional 
• Embossing optional - chosen on Page 2 of the configurator. 
• Adhesive parts are shipped with a roller, cleaner, and application instructions
• Changing from AUTO to SWISS see procedure:   W:\Sales\Sales Tools\Procedures\Epicor Procedures\Signature Swiss Q.docx